Basic Specifications

               Length: 25'                                      Width: 8'6"

                    Draft (hull): 18"                             Weight: 5400# (dry)

                    Height (0n trailer): 10' 4" to 11' (depends on trailer)

                     Max power: 300hp (outboards)

                               Standard Equipment

                     5-year hull warranty                1-piece hand laid hull

                     100% positive floatation         Molded non-skid decks

                      120-gals (US) fuel                       42-gals (US) water

                      33-gal (US) waste tank              Self draining cockpit

                      Sliding side doors                       Aft sliding door

                      Sink                                                   Refrigerator (110v/12v)

                       Shore power

 

 

 ~ $155,000* (plus trailer, taxes, and licensing)

Twin Honda BF135/150 or Yamaha 150 four-stroke outboard engines

This above price is for a water ready boat with the following equipment:

bullet

Twin Honda BF135/150 or Yamaha 150  four-stroke outboard engines

bullet

Three (3) forward windshield wipers

bullet

Windshield washer system (port & starboard forward windows)

bullet

Roof extension (hard top over cockpit)

bullet

Macerator

bullet

Power hull extension (engine bracket)

bullet

Cockpit deck hatches

bullet

Teleflex SeaStar hydraulic steering (wood or stainless wheel)

bullet

Overhead electronics console (custom fitted for each boat)

bullet

Folding aluminum powder-coated radar mast

bullet

Wallas 30D diesel-fired furnace (direct vent) with three outlets and remote panel

bullet

Dickinson propane cooktop (with one 11,000 Btu burner, one 5,000 Btu burner,  and cutting board cover)

bullet

Electric (110-volt) water heater (6 gallon)

bullet

Upgraded faucet (hot/cold) with removable sprayer and one-hand lever operation

bullet

Xantrex ProSine 2.0 (2,000-watt) inverter with 100-amp multi-stage charger and remote panel

bullet

Port & starboard ventilation fans

bullet

Trim tabs (Lenco 12x12 with indicator controller and auto-retract)

bullet

Anchor windlass (V-700 electric with Delta 22# anchor and 330' rode (300' 1/2 nylon rope & 30'  1/4" HT chain))

bullet

Basic safety equipment (PFDs (4), flares, throwable cushion, fire extinguisher, lines (3), fenders (3))

Electronics:

bullet

Raymarine E-120 (12" display) multifunction display

bullet

RayStar 125 GPS sensor (on radar mast)

bullet

DSM 300 digital sounder module with transducer (P66 transom mounted w/speed & temp)

bullet

4 KW radome (24" on radar mast)

bullet

ACR Nauticast Class B AIS transponder with GPS sensor and AIS antenna

bullet

KVH Azimuth 1000 electronic compass (integrated with nav system)

bullet

Standard Horizon Matrix VHF with DSC, PA system (hailer), and fog signals (integrated with nav system)

bullet

Raymarine S-1000 autopilot with wireless remote control (integrated control from E-120)

bullet

JBL AM/FM/CD stereo radio with Sirius satellite radio tuner and antenna (sat radio requires subscription service)

bullet

Full digital gauges for Honda engines with fuel management system

* The hull and factory options are Canadian prices and are subject to change based on current exchange rates; as long as the U.S. dollar and Canadian dollar stay close this pricing won't change much (of course, "in stock" boats don't change).

The above pricing fairly represents "real world" pricing the way most of our RF-246 boats have been outfitted.  Certainly other options can be chosen (or those listed deleted) whether they be engines, electronics or accessories, however the largest pieces of the pie remain the hull and engines so it's difficult to vary the final price of the boat (unless you totally strip it) by large amounts.  For instance a 50% reduction of the cost of the integrated navigation system would only result in a 2.5% change in the overall price of the boat but would vastly change the  operating characteristics of system (and not to the better).  We haven't "loaded" the boat up with options with any intent of pushing profits higher but rather chosen those items which add most to the safety and pleasure of operating the boat.

We are also able to provide a wide range of custom work such as additional shelving, interior trim, canvas enclosure panels, and more.

Please also see our RF-246 outfitting page.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hit Counter